Skip to content

XADO Atomic Metal Conditioner Maximum Diesel Truck for Power Steering Booster

SKU XA 42016
Availability:
in stock, ready to be shipped
Save 35% Save 35%
Original price $29.89
Original price $29.89 - Original price $29.89
Original price $29.89
Current price $19.43
$19.43 - $19.43
Current price $19.43

9AM-5PM CST

Please wait until you receive an email confirmation that your order is ready for pickup

Product Description

The compound is designed for revitalization – repair, restoration, antiwear protection and increase of service life of power steering booster and other hydraulic equipment parts, improvement of lubricating properties of hydraulic fluid.

Special two-component formula of the compound allows to achieve the effect of simultaneous restoration of worn-out parts, their protection against wear and enhancement of lubricating properties of hydraulic fluid.

  • Restores operating surfaces of parts and compensates their current wear
  • Decreases steering force
  • Eliminates pump howl caused by wear
  • Increase pumping capacity
  • Decrease noise and vibration of the hydraulic system pump
  • Improves lubricating properties of hydraulic fluid and tribilogical characteristics of couplongs
  • Increase operating precision of the hydraulic steering booster within 30-60 miles after application
  • Protects parts against wear by low level of hydraulic fluid

Application

Introduce the content of the syringe* into the fluid, which is warmed up to the operating temperature, in the tank of a power steering booster. Start the engine and provide its idle operation during 2-3 minutes. Then turn the steering wheel during 5 minutes with the engine turned on. Drive a car as you normally do. The treatment is considered complete after the mechanism has been in operation for 50 hours or after 950 miles of run.

*1. The temperature of the compound before application should not be lower than +20…+25 0C.

2. It is recommended to preliminary dissolve the content of the syringe in a small amount (about 50ml) of used hydraulic fluid.

3. If the fluid in the tank of a power steering pump is contaminated (opaque or changed its initial color etc.) it’s recommended to change hydraulic fluid before application.

Dosage

30 ml of the product is enough for hydraulic system with capacity of 3-5 l. If hydraulic fluid exceeds 5 liters dosage should be increased at the rate of 30 ml for every 5 l of oil.

Pack

Syringe 30 ml XA 42016

Products by problem solving